I NEED OWNER MANUAL DSP 7000 series 3

BONJOUR à ENLIGHTENED AUDIO DESIGNS COMMUNITY!

Excuse moi,mais je ne parle pas le francais.

I need the DSP 7000 series 3 owner manual because I must change
(using the DIP SWITCH near the HDCD chip) these parameters:


A) 2X - 4X - 8X - OVERSAMPLING

B) DITHER FACTOR

C) OUTPUT VOLTAGE


It may be enough only a photo in JPEG of the page which contains these
arguments.

THANKS IN ADVANCE

Marco.

Hi Marco,
I will send you the details soon.
regards
chris

Hi Marco and Chris,

Can you share what dip switches are doing?

Thanks

The 4x 8x over sampling switch is underneath the HDCD series III board. un plug the DSP7000 and use a small screwdriver to switch the 4x/8x. 8x--push towards back panel, 4x is towards front panel.

output voltage is changed by HDCD dip switch. #12, when #12 is closed = higher output. HDCD dip switch #11 turns on and off the re-clocking circuit--set to closed for re-clocking ON. On the DSP7000 all the other switched (#1--#10) should be OPEN.

hope that helps.

Thank you very much Christophe,
Here are some pictures (click on the link)

Oversampling switch

DIP switch